AGRI-COVER Command-10 Installationshandbuch PDF herunterladen (Seite 23)

Electric Hopper conversion kits will come with 2 arrow decals (PN 80489) per

hopper bottom. Decals are provided to aid operator in opening and closing

hopper doors. Place decal on side of hopper when gate is at both fully open

and fully closed positions (see image below).

NOTE: Location may very depending on trailer manufacturer, may not be

applicable on some trailers.

TO ENABLE MANUAL OVERRIDE:

1. Disconnect Power to hopper motor.

2. Remove stainless steel hair cotter pins and back cover plate.

3. Loosen 3 bolts (see Figure 12), slide motor towards shaft to

loosen chain

4. Remove clip from one of the two master links and remove master

link from chain. Remove chain from sprockets and store components

for later installation. (see illustration below)

Master Link

Master

Link Clip

5. Tighten 3 bolts loosened in

step #3.

6. Attach back cover plate over

shaft and insert tabs into slots

in housing. Secure with

stainless steel hair cotter

pins. (see Figures 14a & 14b)

7. Hopper can now be used with

trailer manufacturer’s handle.

Always remove manufacturer’s handle before connecting

power back to hopper motor

Arrow Decals

1 2 ... 18 19 20 21 22 23 24

Keine Kommentare

AGRI-COVER Command-10 Installationshandbuch Seite 23