AGRI-COVER Command-10 Installationshandbuch PDF herunterladen (Seite 19)

STEP 17

Note: Remote will come pre-programmed from the factory.

Remote control boxes will come numbered from factory to

coincide with function of remote each box has been programmed

to. Refer to Command-10 owner’s manual or the remote

programming video at www.agricover.com/rolltarps/videos for

re-programming and directions to program multiple remotes and

receivers.

Attach remote control box bracket to a rigid location on trailer near

electric hopper motor. Align remote control box, terminals down, with

pre-drilled holes in bracket. Secure using bolts, washers, and nuts

provided.

Select most suitable route for wires usually along frame with existing

harness. Run heavy gauge wire from dual pole connector to remote

control box. Prep wires by stripping off insulation as needed. Slide

heat shrink tube over wire, attach ring terminals and apply heat to

shrink tubes. Bolt terminals tight at dual pole connector. At remote

control box slide rubber boots over wire and attached to terminals.

NOTE: When tightening nuts on terminals always hold base nut

when tightening top nut. Do not over tighten.

Figure 17

Black Motor 1

Red Motor 2

Black –

Install Box

With Terminals

Pointing Down.

Red +

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

AGRI-COVER Command-10 Installationshandbuch Seite 19